Go to the first, previous, next, last section, table of contents.


Overview of Markers

A marker specifies a buffer and a position in that buffer. The marker can be used to represent a position in the functions that require one, just as an integer could be used. See section Positions, for a complete description of positions.

A marker has two attributes: the marker position, and the marker buffer. The marker position is an integer that is equivalent (at a given time) to the marker as a position in that buffer. But the marker's position value can change often during the life of the marker. Insertion and deletion of text in the buffer relocate the marker. The idea is that a marker positioned between two characters remains between those two characters despite insertion and deletion elsewhere in the buffer. Relocation changes the integer equivalent of the marker.

Deleting text around a marker's position leaves the marker between the characters immediately before and after the deleted text. Inserting text at the position of a marker normally leaves the marker either in front of or after the new text, depending on the marker's insertion type (see section Marker Insertion Types)---unless the insertion is done with insert-before-markers (see section Inserting Text).

Insertion and deletion in a buffer must check all the markers and relocate them if necessary. This slows processing in a buffer with a large number of markers. For this reason, it is a good idea to make a marker point nowhere if you are sure you don't need it any more. Unreferenced markers are garbage collected eventually, but until then will continue to use time if they do point somewhere.

Because it is common to perform arithmetic operations on a marker position, most of the arithmetic operations (including + and -) accept markers as arguments. In such cases, the marker stands for its current position.

Here are examples of creating markers, setting markers, and moving point to markers:

;; Make a new marker that initially does not point anywhere:
(setq m1 (make-marker))
     => #<marker in no buffer>

;; Set m1 to point between the 99th and 100th characters
;;   in the current buffer:
(set-marker m1 100)
     => #<marker at 100 in markers.texi>

;; Now insert one character at the beginning of the buffer:
(goto-char (point-min))
     => 1
(insert "Q")
     => nil

;; m1 is updated appropriately.
m1
     => #<marker at 101 in markers.texi>

;; Two markers that point to the same position
;;   are not eq, but they are equal.
(setq m2 (copy-marker m1))
     => #<marker at 101 in markers.texi>
(eq m1 m2)
     => nil
(equal m1 m2)
     => t

;; When you are finished using a marker, make it point nowhere.
(set-marker m1 nil)
     => #<marker in no buffer>


Go to the first, previous, next, last section, table of contents.