Converting Text Representations

Emacs can convert unibyte text to multibyte; it can also convert multibyte text to unibyte, though this conversion loses information. In general these conversions happen when inserting text into a buffer, or when putting text from several strings together in one string. You can also explicitly convert a string's contents to either representation.

Emacs chooses the representation for a string based on the text that it is constructed from. The general rule is to convert unibyte text to multibyte text when combining it with other multibyte text, because the multibyte representation is more general and can hold whatever characters the unibyte text has.

When inserting text into a buffer, Emacs converts the text to the buffer's representation, as specified by enable-multibyte-characters in that buffer. In particular, when you insert multibyte text into a unibyte buffer, Emacs converts the text to unibyte, even though this conversion cannot in general preserve all the characters that might be in the multibyte text. The other natural alternative, to convert the buffer contents to multibyte, is not acceptable because the buffer's representation is a choice made by the user that cannot be overridden automatically.

Converting unibyte text to multibyte text leaves ASCII characters unchanged, and likewise 128 through 159. It converts the non-ASCII codes 160 through 255 by adding the value nonascii-insert-offset to each character code. By setting this variable, you specify which character set the unibyte characters correspond to (see section Character Sets). For example, if nonascii-insert-offset is 2048, which is (- (make-char 'latin-iso8859-1) 128), then the unibyte non-ASCII characters correspond to Latin 1. If it is 2688, which is (- (make-char 'greek-iso8859-7) 128), then they correspond to Greek letters.

Converting multibyte text to unibyte is simpler: it performs logical-and of each character code with 255. If nonascii-insert-offset has a reasonable value, corresponding to the beginning of some character set, this conversion is the inverse of the other: converting unibyte text to multibyte and back to unibyte reproduces the original unibyte text.

Variable: nonascii-insert-offset

This variable specifies the amount to add to a non-ASCII character when converting unibyte text to multibyte. It also applies when self-insert-command inserts a character in the unibyte non-ASCII range, 128 through 255. However, the function insert-char does not perform this conversion.

The right value to use to select character set cs is (- (make-char cs) 128). If the value of nonascii-insert-offset is zero, then conversion actually uses the value for the Latin 1 character set, rather than zero.

Variable: nonascii-translation-table

This variable provides a more general alternative to nonascii-insert-offset. You can use it to specify independently how to translate each code in the range of 128 through 255 into a multibyte character. The value should be a vector, or nil. If this is non-nil, it overrides nonascii-insert-offset.

Function: string-make-unibyte string

This function converts the text of string to unibyte representation, if it isn't already, and returns the result. If string is a unibyte string, it is returned unchanged.

Function: string-make-multibyte string

This function converts the text of string to multibyte representation, if it isn't already, and returns the result. If string is a multibyte string, it is returned unchanged.

Go to the first, previous, next, last section, table of contents.