Node:Installation under UNIX, Next:Device map, Previous:Basic usage, Up:Invoking the grub shell

How to install GRUB via grub

The installation procedure is the same as under the native Stage 2. See Installation, for more information. The command grub-specific information is described here.

What you should be careful about is buffer cache. grub makes use of raw devices instead of filesystems that your operating systems serve, so there exists a potential problem that some cache inconsistency may corrupt your filesystems. What we recommend is:

• If you can unmount drives to which GRUB may write any amount of data, unmount them before running grub.
• If a drive cannot be unmounted but can be mounted with the read-only flag, mount it in read-only mode. That should be secure.
• If a drive must be mounted with the read-write flag, make sure that any activity is not being done on it during running the command grub.
• Reboot your operating system as soon as possible. Probably that is not required if you follow these rules above, but reboot is the most secure way.

In addition, enter the command quit when you finish the installation. That is very important because quit makes the buffer cache consistent. Do not push <C-c>.

If you want to install GRUB non-interactively, specify --batch option in the command-line. This is a simple example:

#!/bin/sh

# Use /usr/sbin/grub if you are on an older system.
/sbin/grub --batch <<EOT 1>/dev/null 2>/dev/null
root (hd0,0)
setup (hd0)
quit
EOT