Go to the first, previous, next, last section, table of contents.


How to Update an Archive Using --update

You must use file name arguments with the --update (-u) operation. If you don't specify any files, tar won't act on any files and won't tell you that it didn't do anything (which may end up confusing you).

@FIXME{note: the above parenthetical added because in fact, this behavior just confused the author. :-) }

To see the `--update' option at work, create a new file, `classical', in your practice directory, and some extra text to the file `blues', using any text editor. Then invoke tar with the `update' operation and the --verbose (-v) option specified, using the names of all the files in the practice directory as file name arguments:

$ tar --update -v -f collection.tar blues folk rock classical
blues
classical
$

Because we have specified verbose mode, tar prints out the names of the files it is working on, which in this case are the names of the files that needed to be updated. If you run `tar --list' and look at the archive, you will see `blues' and `classical' at its end. There will be a total of two versions of the member `blues'; the one at the end will be newer and larger, since you added text before updating it.

(The reason tar does not overwrite the older file when updating it is because writing to the middle of a section of tape is a difficult process. Tapes are not designed to go backward. See section Tapes and Other Archive Media for more information about tapes.

--update (-u) is not suitable for performing backups for two reasons: it does not change directory content entries, and it lengthens the archive every time it is used. The GNU tar options intended specifically for backups are more efficient. If you need to run backups, please consult section Performing Backups and Restoring Files.


Go to the first, previous, next, last section, table of contents.