Go to the first, previous, next, last section, table of contents.

Variables for Fortran Indentation

Several additional variables control how Fortran indentation works:

fortran-do-indent

Extra indentation within each level of `do' statement (default 3).

fortran-if-indent

Extra indentation within each level of `if' statement (default 3). This value is also used for extra indentation within each level of the Fortran 90 `where' statement.

fortran-structure-indent

Extra indentation within each level of `structure', `union', or `map' statements (default 3).

fortran-continuation-indent

Extra indentation for bodies of continuation lines (default 5).

fortran-check-all-num-for-matching-do

If this is nil, indentation assumes that each `do' statement ends on a `continue' statement. Therefore, when computing indentation for a statement other than `continue', it can save time by not checking for a `do' statement ending there. If this is non-nil, indenting any numbered statement must check for a `do' that ends there. The default is nil.

fortran-blink-matching-if

If this is t, indenting an `endif' statement moves the cursor momentarily to the matching `if' statement to show where it is. The default is nil.

fortran-minimum-statement-indent-fixed

Minimum indentation for fortran statements when using fixed format continuation line style. Statement bodies are never indented less than this much. The default is 6.

fortran-minimum-statement-indent-tab

Minimum indentation for fortran statements for tab format continuation line style. Statement bodies are never indented less than this much. The default is 8.

Go to the first, previous, next, last section, table of contents.