Node:dot.biffrc, Previous:Configuring comsatd, Up:comsatd

A per-user configuration file.

By default, when a notification arrives, comsatd prints subject, from headers and the first five lines from the new message to the user's tty. The user is allowed to change this behavior by using his own configuration file. This file should be located in the user's home directory and should be named .biffrc. It must be owned by the user and have its permissions bits set to 0600. (Please note, that the use of per-user configuration files may be disabled, by specifying allow-biffrc no in the main configuration file, see see Configuring comsatd).

The .biffrc file consists of a series of statements. Each statement occupies one line and defines an action to be taken upon arrival of a new mail. Very long lines may be split using \ as the last character on the line. As usual, comments may be introduced with # character.

The actions specified in .biffrc file are executed in turn. The following actions are defined:

beep

Produce an audible signal.

echo string

Output string to user's terminal device.

exec prog arglist

Execute program prog with arguments from arglist. prog must be specified with absolute pathname. It may not be a setuid or setgid program.

In the description above, string denotes any sequence of characters. This sequence must be enclosed in a pair of double-quotes, if it contains whitespace characters. The \ character inside a string starts a C escape sequence. Following meta-characters may be used in strings:

$u

Expands to username

$h

Expands to hostname

$H{name}

Expands to value of message header name.

$B(c,l)

Expands to message body. c and l give maximum number of characters and lines in the expansion. When omitted, they default to 400, 5.

Example I.

Dump to the user's terminal the contents of From and Subject headers followed by at most 5 lines of message body.

echo "Mail to \a$u@$h\a\n---\n\
From: $H{from}\n\
Subject: $H{Subject}\n\
---\n\
$B(,5)\
---\n"

Example II.

Produce a bell, then pop up the xmessage window on display :0.0 with the text formatted in the same manner as in the previous example.

beep
exec /usr/X11R6/bin/xmessage \
-display :0.0 -timeout 10 "Mail to $u@$h \n---\n\
From: $H{from}\n\
Subject: $H{Subject}\n\
---\n\
$B(,5)\
---\n"