[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

12.5 Transforming Program Names When Installing

Autoconf supports changing the names of programs when installing them. In order to use these transformations, `configure.ac' must call the macro AC_ARG_PROGRAM.

Macro: AC_ARG_PROGRAM
Place in output variable program_transform_name a sequence of sed commands for changing the names of installed programs.

If any of the options described below are given to configure, program names are transformed accordingly. Otherwise, if AC_CANONICAL_TARGET has been called and a `--target' value is given, the target type followed by a dash is used as a prefix. Otherwise, no program name transformation is done.

12.5.1 Transformation Options  configure options to transform names
12.5.2 Transformation Examples  Sample uses of transforming names
12.5.3 Transformation Rules  `Makefile' uses of transforming names



This document was generated by Jeff Bailey on December, 24 2002 using texi2html