[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

19.2 stty: Print or change terminal characteristics

stty prints or changes terminal characteristics, such as baud rate. Synopses:

 
stty [option] [setting]...
stty [option]

If given no line settings, stty prints the baud rate, line discipline number (on systems that support it), and line settings that have been changed from the values set by `stty sane'. By default, mode reading and setting are performed on the tty line connected to standard input, although this can be modified by the `--file' option.

stty accepts many non-option arguments that change aspects of the terminal line operation, as described below.

The program accepts the following options. Also see 2. Common options.

`-a'
`--all'
Print all current settings in human-readable form. This option may not be used in combination with any line settings.

`-F device'
`--file=device'
Set the line opened by the filename specified in device instead of the tty line connected to standard input. This option is necessary because opening a POSIX tty requires use of the O_NONDELAY flag to prevent a POSIX tty from blocking until the carrier detect line is high if the clocal flag is not set. Hence, it is not always possible to allow the shell to open the device in the traditional manner.

`-g'
`--save'
Print all current settings in a form that can be used as an argument to another stty command to restore the current settings. This option may not be used in combination with any line settings.

Many settings can be turned off by preceding them with a `-'. Such arguments are marked below with "May be negated" in their description. The descriptions themselves refer to the positive case, that is, when not negated (unless stated otherwise, of course).

Some settings are not available on all POSIX systems, since they use extensions. Such arguments are marked below with "Non-POSIX" in their description. On non-POSIX systems, those or other settings also may not be available, but it's not feasible to document all the variations: just try it and see.

19.2.1 Control settings  
19.2.2 Input settings  
19.2.3 Output settings  
19.2.4 Local settings  
19.2.5 Combination settings  
19.2.6 Special characters  
19.2.7 Special settings  


[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

This document was generated by Jeff Bailey on December, 28 2002 using texi2html