Go to the first, previous, next, last section, table of contents.


Sentinels: Detecting Process Status Changes

A process sentinel is a function that is called whenever the associated process changes status for any reason, including signals (whether sent by Emacs or caused by the process's own actions) that terminate, stop, or continue the process. The process sentinel is also called if the process exits. The sentinel receives two arguments: the process for which the event occurred, and a string describing the type of event.

The string describing the event looks like one of the following:

A sentinel runs only while Emacs is waiting (e.g., for terminal input, or for time to elapse, or for process output). This avoids the timing errors that could result from running them at random places in the middle of other Lisp programs. A program can wait, so that sentinels will run, by calling sit-for or sleep-for (see section Waiting for Elapsed Time or Input), or accept-process-output (see section Accepting Output from Processes). Emacs also allows sentinels to run when the command loop is reading input.

Quitting is normally inhibited within a sentinel--otherwise, the effect of typing C-g at command level or to quit a user command would be unpredictable. If you want to permit quitting inside a sentinel, bind inhibit-quit to nil. See section Quitting.

A sentinel that writes the output into the buffer of the process should check whether the buffer is still alive. If it tries to insert into a dead buffer, it will get an error. If the buffer is dead, (buffer-name (process-buffer process)) returns nil.

If an error happens during execution of a sentinel, it is caught automatically, so that it doesn't stop the execution of whatever programs was running when the sentinel was started. However, if debug-on-error is non-nil, the error-catching is turned off. This makes it possible to use the Lisp debugger to debug the sentinel. See section The Lisp Debugger.

In earlier Emacs versions, every sentinel that did regular expression searching or matching had to explicitly save and restore the match data. Now Emacs does this automatically for sentinels; they never need to do it explicitly. See section The Match Data.

Function: set-process-sentinel process sentinel
This function associates sentinel with process. If sentinel is nil, then the process will have no sentinel. The default behavior when there is no sentinel is to insert a message in the process's buffer when the process status changes.

(defun msg-me (process event)
   (princ
     (format "Process: %s had the event `%s'" process event)))
(set-process-sentinel (get-process "shell") 'msg-me)
     => msg-me
(kill-process (get-process "shell"))
     -| Process: #<process shell> had the event `killed'
     => #<process shell>

Function: process-sentinel process
This function returns the sentinel of process, or nil if it has none.

Function: waiting-for-user-input-p
While a sentinel or filter function is running, this function returns non-nil if Emacs was waiting for keyboard input from the user at the time the sentinel or filter function was called, nil if it was not.


Go to the first, previous, next, last section, table of contents.