[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

M.7.8.1 Making and Using Snapshots

There are two basic commands for snapshots; one makes a snapshot with a given name, the other retrieves a named snapshot.

C-x v s name RET
Define the last saved versions of every registered file in or under the current directory as a snapshot named name (vc-create-snapshot).

C-x v r name RET
For all registered files at or below the current directory level, select whatever versions correspond to the snapshot name (vc-retrieve-snapshot).

This command reports an error if any files are locked at or below the current directory, without changing anything; this is to avoid overwriting work in progress.

A snapshot uses a very small amount of resources--just enough to record the list of file names and which version belongs to the snapshot. Thus, you need not hesitate to create snapshots whenever they are useful.

You can give a snapshot name as an argument to C-x v = or C-x v ~ (see section M.7.4 Examining And Comparing Old Versions). Thus, you can use it to compare a snapshot against the current files, or two snapshots against each other, or a snapshot against a named version.



This document was generated on April 2, 2002 using texi2html