U.5.1 Comment Commands

The comment commands in this table insert, kill and align comments. They are described in this section and following sections.

M-;

Insert or realign comment on current line; alternatively, comment or uncomment the region (comment-dwim).

C-u M-;

Kill comment on current line (comment-kill).

C-x ;

Set comment column (comment-set-column).

C-M-j

Like RET followed by inserting and aligning a comment (comment-indent-new-line).

M-x comment-region

Add or remove comment delimiters on all the lines in the region.

The command to create or align a comment is M-; (comment-dwim). The word "dwim" is an acronym for "Do What I Mean"; it indicates that this command can be used for many different jobs relating to comments, depending on the situation where you use it.

If there is no comment already on the line, M-; inserts a new comment, aligned at a specific column called the comment column. The new comment begins with the string Emacs thinks comments should start with (the value of comment-start; see below). Point is after that string, so you can insert the text of the comment right away. If the major mode has specified a string to terminate comments, M-; inserts that too, to keep the syntax valid.

If the text of the line extends past the comment column, then the comment start string is indented to a suitable boundary (usually, at least one space is inserted).

You can also use M-; to align an existing comment. If a line already contains the comment-start string, M-; reindents it to the conventional alignment and moves point after it. (Exception: comments starting in column 0 are not moved.) Even when an existing comment is properly aligned, M-; is still useful for moving directly to the start of the text inside the comment.

C-u M-; kills any comment on the current line, along with the whitespace before it. To reinsert the comment on another line, move to the end of that line, do C-y, and then do M-; to realign it.

Note that C-u M-; is not a distinct key; it is M-; (comment-dwim) with a prefix argument. That command is programmed so that when it receives a prefix argument it calls comment-kill. However, comment-kill is a valid command in its own right, and you can bind it directly to a key if you wish.

M-; does two other jobs when used with an active region in Transient Mark mode (see section H.2 Transient Mark Mode). Then it either adds or removes comment delimiters on each line of the region. (If every line is a comment, it removes comment delimiters from each; otherwise, it adds comment delimiters to each.) If you are not using Transient Mark mode, then you should use the commands comment-region and uncomment-region to do these jobs (see section U.5.2 Multiple Lines of Comments). A prefix argument used in these circumstances specifies how many comment delimiters to add or how many to delete.

Some major modes have special rules for indenting certain kinds of comments in certain contexts. For example, in Lisp code, comments which start with two semicolons are indented as if they were lines of code, instead of at the comment column. Comments which start with three semicolons are supposed to start at the left margin. Emacs understands these conventions by indenting a double-semicolon comment using TAB, and by not changing the indentation of a triple-semicolon comment at all.

;; This function is just an example ;;; Here either two or three semicolons are appropriate. (defun foo (x) ;;; And now, the first part of the function: ;; The following line adds one. (1+ x)) ; This line adds one.

In C code, a comment preceded on its line by nothing but whitespace is indented like a line of code.