[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

I.1 Saving Positions in Registers

Saving a position records a place in a buffer so that you can move back there later. Moving to a saved position switches to that buffer and moves point to that place in it.

C-x r SPC r
Save position of point in register r (point-to-register).
C-x r j r
Jump to the position saved in register r (jump-to-register).

To save the current position of point in a register, choose a name r and type C-x r SPC r. The register r retains the position thus saved until you store something else in that register.

The command C-x r j r moves point to the position recorded in register r. The register is not affected; it continues to hold the same position. You can jump to the saved position any number of times.

If you use C-x r j to go to a saved position, but the buffer it was saved from has been killed, C-x r j tries to create the buffer again by visiting the same file. Of course, this works only for buffers that were visiting files.



This document was generated on April 2, 2002 using texi2html