The D10V version of
as uses the instruction names in the D10V
Architecture Manual. However, the names in the manual are sometimes ambiguous.
There are instruction names that can assemble to a short or long form opcode.
How does the assembler pick the correct form?
as will always pick the
smallest form if it can. When dealing with a symbol that is not defined yet when a
line is being assembled, it will always use the long form. If you need to force the
assembler to use either the short or long form of the instruction, you can append
either `.s' (short) or `.l' (long) to it. For example, if you are writing
an assembly program and you want to do a branch to a symbol that is defined later
in your program, you can write `bra.s foo'.
Objdump and GDB will always append `.s' or `.l' to instructions which
have both short and long forms.
Go to the first, previous, next, last section, table of contents.