In some applications, it is not feasible for the debugger to interrupt the program's execution long enough for the developer to learn anything helpful about its behavior. If the program's correctness depends on its real-time behavior, delays introduced by a debugger might cause the program to change its behavior drastically, or perhaps fail, even when the code itself is correct. It is useful to be able to observe the program's behavior without interrupting it.
Using GDB's trace and collect commands, you can
specify locations in the program, called tracepoints, and
arbitrary expressions to evaluate when those tracepoints are reached.
Later, using the tfind command, you can examine the values
those expressions had when the program hit the tracepoints. The
expressions may also denote objects in memory--structures or arrays,
for example--whose values GDB should record; while visiting
a particular tracepoint, you may inspect those objects as if they were
in memory at that moment. However, because GDB records these
values without interacting with you, it can do so quickly and
unobtrusively, hopefully not disturbing the program's behavior.
The tracepoint facility is currently available only for remote targets. See section Specifying a Debugging Target. In addition, your remote target must know how to collect trace data. This functionality is implemented in the remote stub; however, none of the stubs distributed with GDB support tracepoints as of this writing.
This chapter describes the tracepoint commands and features.
Go to the first, previous, next, last section, table of contents.