Go to the first, previous, next, last section, table of contents.


Atomicity of Pipe I/O

Reading or writing pipe data is atomic if the size of data written is not greater than PIPE_BUF. This means that the data transfer seems to be an instantaneous unit, in that nothing else in the system can observe a state in which it is partially complete. Atomic I/O may not begin right away (it may need to wait for buffer space or for data), but once it does begin it finishes immediately.

Reading or writing a larger amount of data may not be atomic; for example, output data from other processes sharing the descriptor may be interspersed. Also, once PIPE_BUF characters have been written, further writes will block until some characters are read.

See section Limits on File System Capacity, for information about the PIPE_BUF parameter.


Go to the first, previous, next, last section, table of contents.