Go to the first, previous, next, last section, table of contents.


Sending Data

The send function is declared in the header file `sys/socket.h'. If your flags argument is zero, you can just as well use write instead of send; see section Input and Output Primitives. If the socket was connected but the connection has broken, you get a SIGPIPE signal for any use of send or write (see section Miscellaneous Signals).

Function: int send (int socket, void *buffer, size_t size, int flags)
The send function is like write, but with the additional flags flags. The possible values of flags are described in section Socket Data Options.

This function returns the number of bytes transmitted, or -1 on failure. If the socket is nonblocking, then send (like write) can return after sending just part of the data. See section File Status Flags, for information about nonblocking mode.

Note, however, that a successful return value merely indicates that the message has been sent without error, not necessarily that it has been received without error.

The following errno error conditions are defined for this function:

EBADF
The socket argument is not a valid file descriptor.
EINTR
The operation was interrupted by a signal before any data was sent. See section Primitives Interrupted by Signals.
ENOTSOCK
The descriptor socket is not a socket.
EMSGSIZE
The socket type requires that the message be sent atomically, but the message is too large for this to be possible.
EWOULDBLOCK
Nonblocking mode has been set on the socket, and the write operation would block. (Normally send blocks until the operation can be completed.)
ENOBUFS
There is not enough internal buffer space available.
ENOTCONN
You never connected this socket.
EPIPE
This socket was connected but the connection is now broken. In this case, send generates a SIGPIPE signal first; if that signal is ignored or blocked, or if its handler returns, then send fails with EPIPE.

This function is defined as a cancellation point in multi-threaded programs, so one has to be prepared for this and make sure that allocated resources (like memory, files descriptors, semaphores or whatever) are freed even if the thread is canceled.


Go to the first, previous, next, last section, table of contents.