Node:DOS/Windows, Next:SCO UnixWare, Previous:OpenBSD, Up:OS-specific notes
GRUB cannot boot DOS or Windows directly, so you must chain-load them (see Chain-loading). However, their boot loaders have some critical deficiencies, so it may not work to just chain-load them. To overcome the problems, GRUB provides you with two helper functions.
If you have installed DOS (or Windows) on a non-first hard disk, you
have to use the disk swapping technique, because that OS cannot boot
from any disks but the first one. The workaround used in GRUB is the
command map (see map), like this:
grub> map (hd0) (hd1) grub> map (hd1) (hd0)
This performs a virtual swap between your first and second hard drive.
Caution: This is effective only if DOS (or Windows) uses BIOS to access the swapped disks. If that OS uses a special driver for the disks, this probably won't work.
Another problem arises if you installed more than one set of DOS/Windows onto one disk, because they could be confused if there are more than one primary partitions for DOS/Windows. Certainly you should avoid doing this, but there is a solution if you do want to do so. Use the partition hiding/unhiding technique.
If GRUB hides a DOS (or Windows) partition (see hide), DOS (or
Windows) will ignore the partition. If GRUB unhides a DOS (or
Windows) partition (see unhide), DOS (or Windows) will detect the
partition. Thus, if you have installed DOS (or Windows) on the first
and the second partition of the first hard disk, and you want to boot
the copy on the first partition, do the following:
grub> unhide (hd0,0) grub> hide (hd0,1) grub> rootnoverify (hd0,0) grub> chainloader +1 grub> makeactive grub> boot