Evaluating integer expressions

Integer expressions are evaluated with eval:

eval(expression, opt radix, opt width)

which expands to the value of expression.

Expressions can contain the following operators, listed in order of decreasing precedence.

-

Unary minus

**

Exponentiation

* / %

Multiplication, division and modulo

+ -

Addition and subtraction

<< >>

Shift left or right

== != > >= < <=

Relational operators

!

Logical negation

~

Bitwise negation

&

Bitwise and

^

Bitwise exclusive-or

|

Bitwise or

&&

Logical and

||

Logical or

All operators, except exponentiation, are left associative.

Note that many m4 implementations use `^' as an alternate operator for the exponentiation, while many others use `^' for the bitwise exclusive-or. GNU m4 changed its behavior: it used to exponentiate for `^', it now computes the bitwise exclusive-or.

Numbers without special prefix are given decimal. A simple `0' prefix introduces an octal number. `0x' introduces an hexadecimal number. `0b' introduces a binary number. `0r' introduces a number expressed in any radix between 1 and 36: the prefix should be immediately followed by the decimal expression of the radix, a colon, then the digits making the number. For any radix, the digits are `0', `1', `2', .... Beyond `9', the digits are `a', `b' ... up to `z'. Lower and upper case letters can be used interchangeably in numbers prefixes and as number digits.

Parentheses may be used to group subexpressions whenever needed. For the relational operators, a true relation returns 1, and a false relation return 0.

Here are a few examples of use of eval.

eval(-3 * 5)
=>-15
eval(index(`Hello world', `llo') >= 0)
=>1
define(`square', `eval(($1)**2)')
=>
square(9)
=>81
square(square(5)+1)
=>676
define(`foo', `666')
=>
eval(`foo'/6)
error-->51.eval:14: m4: Bad expression in eval: foo/6
=>
eval(foo/6)
=>111

As the second to last example shows, eval does not handle macro names, even if they expand to a valid expression (or part of a valid expression). Therefore all macros must be expanded before they are passed to eval.

If radix is specified, it specifies the radix to be used in the expansion. The default radix is 10. The result of eval is always taken to be signed. The width argument specifies a minimum output width. The result is zero-padded to extend the expansion to the requested width.

eval(666, 10)
=>666
eval(666, 11)
=>556
eval(666, 6)
=>3030
eval(666, 6, 10)
=>0000003030
eval(-666, 6, 10)
=>-000003030

Take note that radix cannot be larger than 36.

The builtin macro eval is recognized only when given arguments.

Go to the first, previous, next, last section, table of contents.