To include another file within a Texinfo file, write the
@include command at the beginning of a line and follow it on
the same line by the name of a file to be included. For
example:
@include buffers.texi
An included file should simply be a segment of text that you expect to
be included as is into the overall or outer Texinfo file; it
should not contain the standard beginning and end parts of a Texinfo
file. In particular, you should not start an included file with a
line saying `\input texinfo'; if you do, that phrase is inserted
into the output file as is. Likewise, you should not end an included
file with an @bye command; nothing after @bye is
formatted.
In the past, you were required to write an @setfilename line at the
beginning of an included file, but no longer. Now, it does not matter
whether you write such a line. If an @setfilename line exists
in an included file, it is ignored.
Conventionally, an included file begins with an @node line that
is followed by an @chapter line. Each included file is one
chapter. This makes it easy to use the regular node and menu creating
and updating commands to create the node pointers and menus within the
included file. However, the simple Emacs node and menu creating and
updating commands do not work with multiple Texinfo files. Thus you
cannot use these commands to fill in the `Next', `Previous', and `Up'
pointers of the @node line that begins the included file. Also,
you cannot use the regular commands to create a master menu for the
whole file. Either you must insert the menus and the `Next',
`Previous', and `Up' pointers by hand, or you must use the GNU Emacs
Texinfo mode command, texinfo-multiple-files-update, that is
designed for @include files.
Go to the first, previous, next, last section, table of contents.