Go to the first, previous, next, last section, table of contents.
Typesetting and printing a Texinfo file is a multi-step process in which
you first create a file for printing (called a DVI file), and then
print the file. Optionally, you may also create indices. To do this,
you must run the texindex command after first running the
tex typesetting command; and then you must run the tex
command again. Or else run the texi2dvi command which
automatically creates indices as needed (see section Format with texi2dvi).
Often, when you are writing a document, you want to typeset and print
only part of a file to see what it will look like. You can use the
texinfo-tex-region and related commands for this purpose. Use
the texinfo-tex-buffer command to format all of a
buffer.
texi2dvi on the buffer. In addition to running TeX on the
buffer, this command automatically creates or updates indices as
needed.
texindex to sort the indices of a Texinfo file formatted with
texinfo-tex-region. The texinfo-tex-region command does
not run texindex automatically; it only runs the tex
typesetting command. You must run the texinfo-tex-region command
a second time after sorting the raw index files with the texindex
command. (Usually, you do not format an index when you format a region,
only when you format a buffer. Now that the texi2dvi command
exists, there is little or no need for this command.)
texinfo-tex-buffer or texinfo-tex-region.
For texinfo-tex-region or texinfo-tex-buffer to work, the
file must start with a `\input texinfo' line and must
include an @settitle line. The file must end with @bye
on a line by itself. (When you use texinfo-tex-region, you must
surround the @settitle line with start-of-header and
end-of-header lines.)
See section Formatting and Printing Hardcopy, for a description of the other TeX related
commands, such as tex-show-print-queue.
Go to the first, previous, next, last section, table of contents.