Go to the first, previous, next, last section, table of contents.


The @headings Command

The @headings command is rarely used. It specifies what kind of page headings and footings to print on each page. Usually, this is controlled by the @setchapternewpage command. You need the @headings command only if the @setchapternewpage command does not do what you want, or if you want to turn off pre-defined page headings prior to defining your own. Write an @headings command immediately after the @end titlepage command.

You can use @headings as follows:

@headings off
Turn off printing of page headings.
@headings single
Turn on page headings appropriate for single-sided printing.
@headings double
@headings on
Turn on page headings appropriate for double-sided printing. The two commands, @headings on and @headings double, are synonymous.
@headings singleafter
@headings doubleafter
Turn on single or double headings, respectively, after the current page is output.
@headings on
Turn on page headings: single if `@setchapternewpage on', double otherwise.

For example, suppose you write @setchapternewpage off before the @titlepage command to tell TeX to start a new chapter on the same page as the end of the last chapter. This command also causes TeX to typeset page headers for single-sided printing. To cause TeX to typeset for double sided printing, write @headings double after the @end titlepage command.

You can stop TeX from generating any page headings at all by writing @headings off on a line of its own immediately after the line containing the @end titlepage command, like this:

@end titlepage
@headings off

The @headings off command overrides the @end titlepage command, which would otherwise cause TeX to print page headings.

You can also specify your own style of page heading and footing. See section Page Headings, for more information.


Go to the first, previous, next, last section, table of contents.