Go to the first, previous, next, last section, table of contents.
The @chapter, @section, and other structuring commands
supply the information to make up a table of contents, but they do not
cause an actual table to appear in the manual. To do this, you must use
the @contents and/or @summarycontents command(s).
@contents
@heading
series of commands do not appear in the table of contents.)
@shortcontents
@summarycontents
@summarycontents is a synonym for @shortcontents; the
two commands are exactly the same.)
Generate a short or summary table of contents that lists only the
chapters (and appendices and unnumbered chapters). Omit sections, subsections
and subsubsections. Only a long manual needs a short table
of contents in addition to the full table of contents.
Both contents commands should be written on a line by themselves.
The contents commands automatically generate a chapter-like heading at
the top of the first table of contents page, so don't include any
sectioning command such as @unnumbered before them.
Since an Info file uses menus instead of tables of contents, the Info
formatting commands ignore the contents commands. But the contents are
included in plain text output (generated by makeinfo --no-headers).
The contents commands can be placed either at the very end of the file,
after any indices (see the previous section) and just before the
@bye (see the next section), or near the beginning of the file,
after the @end titlepage (see section @titlepage). The advantage to
the former is that then the contents output is always up to date,
because it reflects the processing just done. The advantage to the
latter is that the contents are printed in the proper place, thus you do
not need to rearrange the DVI file with @command{dviselect} or shuffle
paper. However, contents commands at the beginning of the document are
ignored when outputting to standard output.
As an author, you can put the contents commands wherever you prefer.
But if you are a user simply printing a manual, you may wish to print
the contents after the title page even if the author put the contents
commands at the end of the document (as is the case in most existing
Texinfo documents). You can do this by specifying
@setcontentsaftertitlepage and/or
@setshortcontentsaftertitlepage. The first prints only the main
contents after the @end titlepage; the second prints both the
short contents and the main contents. In either case, any subsequent
@contents or @shortcontents is ignored (unless no
@end titlepage is ever encountered).
You need to include the @set...contentsaftertitlepage
commands early in the document (just after @setfilename, for
example). Or, if you're using @command{texi2dvi} (see section Format with @code{texi2dvi}), you can use its @option{--texinfo} option to specify this
without altering the source file at all. For example:
texi2dvi --texinfo=@setshortcontentsaftertitlepage foo.texi
Go to the first, previous, next, last section, table of contents.