Go to the first, previous, next, last section, table of contents.

@anchor: Defining Arbitrary Cross-reference Targets

An anchor is a position in your document, labeled so that cross-references can refer to it, just as they can to nodes. You create an anchor with the @anchor command, and give the label as a normal brace-delimited argument. For example:

This marks the @anchor{x-spot}spot.
...
@xref{x-spot,,the spot}.

produces:

This marks the spot.
...
See [the spot], page 1.

As you can see, the @anchor command itself produces no output. This example defines an anchor `x-spot' just before the word `spot'. You can refer to it later with an @xref or other cross-reference command, as shown. See section Cross References, for details on the cross-reference commands.

It is best to put @anchor commands just before the position you wish to refer to; that way, the reader's eye is led on to the correct text when they jump to the anchor. You can put the @anchor command on a line by itself if that helps readability of the source. Spaces are always ignored after @anchor.

Anchor names and node names may not conflict. Anchors and nodes are given similar treatment in some ways; for example, the goto-node command in standalone Info takes either an anchor name or a node name as an argument. (See section `goto-node' in GNU Info.)

Go to the first, previous, next, last section, table of contents.