Node:Running Info-Validate, Previous:Using occur, Up:Catching Mistakes



Finding Badly Referenced Nodes

You can use the Info-validate command to check whether any of the `Next', `Previous', `Up' or other node pointers fail to point to a node. This command checks that every node pointer points to an existing node. The Info-validate command works only on Info files, not on Texinfo files.

The makeinfo program validates pointers automatically, so you do not need to use the Info-validate command if you are using makeinfo. You only may need to use Info-validate if you are unable to run makeinfo and instead must create an Info file using texinfo-format-region or texinfo-format-buffer, or if you write an Info file from scratch.