[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

19.2.2 Input settings

`ignbrk'
Ignore break characters. May be negated.

`brkint'
Make breaks cause an interrupt signal. May be negated.

`ignpar'
Ignore characters with parity errors. May be negated.

`parmrk'
Mark parity errors (with a 255-0-character sequence). May be negated.

`inpck'
Enable input parity checking. May be negated.

`istrip'
Clear high (8th) bit of input characters. May be negated.

`inlcr'
Translate newline to carriage return. May be negated.

`igncr'
Ignore carriage return. May be negated.

`icrnl'
Translate carriage return to newline. May be negated.

`ixon'
Enable XON/XOFF flow control (that is, CTRL-S/CTRL-Q). May be negated.

`ixoff'
`tandem'
Enable sending of stop character when the system input buffer is almost full, and start character when it becomes almost empty again. May be negated.

`iuclc'
Translate uppercase characters to lowercase. Non-POSIX. May be negated.

`ixany'
Allow any character to restart output (only the start character if negated). Non-POSIX. May be negated.

`imaxbel'
Enable beeping and not flushing input buffer if a character arrives when the input buffer is full. Non-POSIX. May be negated.



This document was generated by Jeff Bailey on December, 28 2002 using texi2html