Characters that Cause Signals

These special characters may be active in either canonical or noncanonical input mode, but only when the ISIG flag is set (see section Local Modes).

Macro: int VINTR

This is the subscript for the INTR character in the special control character array. termios.c_cc[VINTR] holds the character itself.

The INTR (interrupt) character raises a SIGINT signal for all processes in the foreground job associated with the terminal. The INTR character itself is then discarded. See section Signal Handling, for more information about signals.

Typically, the INTR character is C-c.

Macro: int VQUIT

This is the subscript for the QUIT character in the special control character array. termios.c_cc[VQUIT] holds the character itself.

The QUIT character raises a SIGQUIT signal for all processes in the foreground job associated with the terminal. The QUIT character itself is then discarded. See section Signal Handling, for more information about signals.

Typically, the QUIT character is C-\.

Macro: int VSUSP

This is the subscript for the SUSP character in the special control character array. termios.c_cc[VSUSP] holds the character itself.

The SUSP (suspend) character is recognized only if the implementation supports job control (see section Job Control). It causes a SIGTSTP signal to be sent to all processes in the foreground job associated with the terminal. The SUSP character itself is then discarded. See section Signal Handling, for more information about signals.

Typically, the SUSP character is C-z.

Few applications disable the normal interpretation of the SUSP character. If your program does this, it should provide some other mechanism for the user to stop the job. When the user invokes this mechanism, the program should send a SIGTSTP signal to the process group of the process, not just to the process itself. See section Signaling Another Process.

Macro: int VDSUSP

This is the subscript for the DSUSP character in the special control character array. termios.c_cc[VDSUSP] holds the character itself.

The DSUSP (suspend) character is recognized only if the implementation supports job control (see section Job Control). It sends a SIGTSTP signal, like the SUSP character, but not right away--only when the program tries to read it as input. Not all systems with job control support DSUSP; only BSD-compatible systems (including the GNU system).

See section Signal Handling, for more information about signals.

Typically, the DSUSP character is C-y.

Go to the first, previous, next, last section, table of contents.